I have a 06 450 rhino and about 4 months ago i was rideing down the road and felt a slight vibration when goin up a long hill. About a mile down the road the vibration came back then all of a sudden it got real bad and it sounded like something tried locking up under my seat. After i stopped and tried putting it in gear it would move about 10" and would just stop and wouldnt move anymore the motor starts and idles but wont pull its self with out trying to lock up. So when i hualed it home i pulled clutch cover off and the notches on the belt where all laying everywhere in the clutch cover and under the clutch. So i took belt off today and went to put a new one on and when i started it it wouldnt go into gear with the gear shifter. Finaly unhooked linkedge and used a wrench to put it in gear but when i give it gas a grinding sound comes from the clutch and it shuts down the rhino. Need help with clutch problems and why it wont go in to gear from shifter. When i spin the clutch counter clock wise it sounds like a bearing behind it is dry but has no up and down or side to side play. Plz help thanks.
↧